Projects / Electrical / Electrical project 89

Fire Alarm Panel with Zone Indication and Sprinkler Control

Approx. component budget: Rs. 4,000 - 8,000

Objective

Build a small fire alarm panel that identifies the zone in alarm and acts as per a simple cause-and-effect plan.

What you will build

A multi-zone alarm panel with smoke and heat detectors, zone LEDs, a hooter, and an output that starts a pump or sprinkler model.

Results you can expect

• Detection and alarm delay per zone
• False alarm rate over 24 hours
• Line-fault (open or short) detection
• And a cause-and-effect table

What you will learn

Fire detection logic, supervised circuits and safety documentation.

Tools and notes

Smoke sensors (MQ-2 or optical module) and heat sensors, Arduino/ESP32, relay and buzzer. Test only with safe sources such as a small incense stick and never with real flame indoors.

Resume points from this project

• Built and tested Fire Alarm Panel with Zone Indication and Sprinkler Control; objective: build a small fire alarm panel that identifies the zone in alarm and acts as per a simple cause-and-effect plan.
• Measured and analysed detection and alarm delay per zone and false alarm rate over 24 hours; wrote the report and presented the results in a viva. Add your own numbers: [x].

Replace [x] with your own measured results. Write only what you really did.

More electrical projects

Back to all projects