Projects / Electrical / Electrical project 74

SEPIC and Cuk Converters: Side-by-Side Comparison

Power ElectronicsMedium

Approx. component budget: Rs. 3,500 - 6,500

Objective

Compare the converters on ripple, efficiency and response across a changing input voltage.

Two converters built for the same input and output that can step voltage up or down, with the same load and measurement set-up.

Non-inverting and inverting buck-boost converters, coupled inductors and design trade-offs.

Controller IC or Arduino PWM, MOSFET, inductors, capacitors, scope. Use a low-voltage bench supply and a current limit.

Built and tested SEPIC and Cuk Converters: Side-by-Side Comparison; objective: compare the converters on ripple, efficiency and response across a changing input voltage.
Measured and analysed efficiency vs input voltage and output ripple; wrote the report and presented the results in a viva. Add your own numbers: [x].

Replace [x] with your own measured results. Write only what you really did.

The short guide for this project is prepared when you ask for it. Message us on WhatsApp and we will prepare it and tell you when it is ready.

Payment details are shared in the chat. We send the PDF on WhatsApp after your payment is confirmed.

Compare the energy harvested by an MPPT controller with a simple PWM controller under changing sunlight and sh...

Build an inverter and measure its output waveform quality, efficiency and voltage regulation at different load...

Measure how power transfer efficiency changes with coil gap, misalignment, frequency and coil size...